-
Junior Member
registered user
Problem Installing
Hi. I am trying to install knoppix 3.3 on the hd. I have no partitions on the disk. When, the program of partitioning runs, I make the partitions and try to write them. When I put write, and answer "yes", the program stops working (the cdrom stops reading also).
Thanks,
Tomas Zulberti
-
Senior Member
registered user
tzulberti,
Only thing I can think of...
Check your BIOS, see if you have any ANTI-VIRUS, or BOOT SECTOR protection enabled... Some of the "older" BIOS's ( I had one ) that used this to "protect" the disk from "low-level" tampering - most of the time, viri can attack the MBR, but some of the viri would "tinker" with the partition information, thus making your hard drive not work. This is my best guess on this...
If it is a new hard drive, and completely empty - check that your cables are completely inserted, just one pin on that cable can cause problems if it isn't making full contact. Knoppix v3.3 was a lot easier to cfdisk than with v3.4 - You can also try running cfdisk before you run the install program -=- one more thing - you are doing all of this as root aren't you? do a su and be sure your prompt has root@... in front of it... You have to be root to do the cfdisk, and the install... Just some ideas...
Ms. Cuddles
-
Junior Member
registered user
I have tried that. But it still hangs up. When the program starts, it says the something like: "No partition table or wrong.... Do you want to start with a new one [Y/n]: ?"
Thanks anyway.
Tomas Zulberti
Similar Threads
-
By Compmad in forum Hdd Install / Debian / Apt
Replies: 3
Last Post: 04-29-2005, 06:58 AM
-
By Apollo2004 in forum Hdd Install / Debian / Apt
Replies: 3
Last Post: 03-12-2005, 11:54 PM
-
By rangalo in forum Hdd Install / Debian / Apt
Replies: 2
Last Post: 02-01-2005, 12:35 PM
-
By mementomike in forum General Support
Replies: 3
Last Post: 03-21-2004, 03:27 AM
-
By Wikt in forum Hardware & Booting
Replies: 3
Last Post: 01-10-2004, 03:38 PM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Cisco SG110 8 Port Gigabit Ethernet Switch SG110D-08-UK
$39.00
Cisco SG110 24 Port Gigabit Ethernet Switch w/ 2 x SFP SG110-24
$117.00
Cisco SG95-16 16-Port Gigabit Switch SG95-16-SG
$47.00
8 Ports Unmanaged Industrial Ethernet Switch Network Gigabit Ethernet Switch
$85.00
New Linksys SE3005 5-port Gigabit Ethernet Switch
$18.99
New 10/100 Mbps 8 Ports Fast Ethernet LAN Desktop RJ45 Network Switch Hub
$11.49
NetGear ProSafe GS748T V4 48-Port Gigabit Smart Switch w/ Ears + Cord
$30.00
Linksys SE3008 8 Ports Rack Mountable Gigabit Ethernet Switch
$21.99
Fortinet FortiSwitch FS-124D-POE 24 Port Gigabit Ethernet Switch UNREGISTERED
$99.97
Netgear ProSafe S3300-52X-POE+ 48-Port Gigabit PoE+ Stackable Network Switch
$99.99