-
Horizontal Sync
I'm using Knoppix 3.4 with a Panasonic S17 monitor which accepts input signals with horizontal frequency 30kHz to 69kHz and vertical frequency 50Hz to 160Hz. Problem is the horizontal sync is off and my screen has several copies of the page to be shown which are at about a 45 degree angle tilted left and which slide across the screen. Knoppix hsync is 78kHz which I assume is the problem. Am I correct and, if so, how can it be fixed? I tried to boot using the option Knoppix vsync=85 hsync=69 but then the program stops responding. I'm using an Athlon cpu at 850MHz. My purpose in using Knoppix is to rescue a data partition on an unbootable Windows machine. Any help will be greatly appreciated.
-
RE: Hsync
try the following
knoppix screen=1024x768 vsync=90 hsync=75
on the monitor I was using before it finally died I had to use
knoppix screen=1024x768 vsync=60 hsync=60
knoppix's default is 1280x1024, my monitor only went to 1024x768.
my monitor wouldn't lock onto vsync above 60.
( should have, but wouldn't.....)
any vga monitor should work at 800x600 vsync=60 hsync=60
.... unless the smoke got out of one of the parts.....
Similar Threads
-
By jiohdi in forum The Lounge
Replies: 0
Last Post: 01-13-2005, 07:35 PM
-
By mikejn1 in forum General Support
Replies: 0
Last Post: 11-29-2004, 04:50 PM
-
By lothario in forum Networking
Replies: 0
Last Post: 03-15-2004, 01:32 AM
-
By Leeb in forum General Support
Replies: 9
Last Post: 01-22-2004, 07:26 AM
-
By Tony in forum General Support
Replies: 3
Last Post: 12-28-2002, 11:17 AM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
MITS Altair 680 Case Only LS3
$500.00
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$359.99