as root, type #modprobe ipw2100, or modprobe ipw2200 if you have the a/b/g card
then #pump -i eth1
I got Knoppix to run fine on my Thinpad R50 but I can't get my Wi-Fi to work with it...
It has build in a wireless card...
I tried wlcardconfig and it said no card detected
I also tried netcardconfig and nothin there either...
Any ideas...
Thanks for you help
as root, type #modprobe ipw2100, or modprobe ipw2200 if you have the a/b/g card
then #pump -i eth1
I tried both of those commands...
both failed...
any other ideas...?
thanks though
I just posted a reply in another thread, please try it and report your results: http://www.knoppix.net/forum/viewtop...r=asc&start=10
I hope it helps,
G
Hello,
I also have a ThinkPad R50.
I ran into the same issue with my internal wi-fi card not being detected. I was using a couple of older version of Knoppix and recently downloaded the latest which was 3.6. This version contained the drivers necessary.
When you download and use version 3.6 you will need to run the wlcardconfig utility to setup the wi-fi parameters and then your netcardconfig to setup the eth0 for DHCP.
Hope that helps.
JG
If you have the a/b/g card it is ath1. Try pump -i ath1
That works for my t41 with the atheros a/b/g card.
Good luck.
-PaulK
Cisco Systems NCS2K-20-SMRFS-L optical multiplexor CISCO EXCESS
$3599.00
Cisco SG110 24 Port Gigabit Ethernet Switch w/ 2 x SFP SG110-24
$117.00
Cisco QSFP-40/100-SRBD 100GE/40GE BASE-SR-BiDi LC QSFP Transceiver Hologram 1PCS
$200.00
Cisco RV160 VPN Router 4 Gigabit Ethernet Ports RV160-K9-AR
$80.00
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W+ C3850-NM-4-1G Mod
$83.00
Cisco Catalyst WS-C2960-48TT-L V02 48 Port Fast Ethernet Switch
$34.00
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$38.99
Cisco WS-C4948-10GE-S 4948-10GE 48 Port Gigabit +10GB Switch w single AC 15.0 OS
$99.99
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W Network Switch
$41.58
Cisco MS410-16-HW 16 Ports Fully Managed Ethernet Switch NEW Unclaimed
$999.99