I just had a quick look at kGeo, it appears it may not be capable of doing what you want. Have a look at Qcad. It's actually a CAD drafting program but I think you can do lines entered from co-ordinate points with it.
Ok, so KGEO might not be familiar to all of you, but it is the free alternative to a $40 progeam called Geometer's Sketchpad. I am homeschooled and woking on Geometry. Soon to do constructions, this software would be VERY useful.
I ran into a problem, however. I cannot figure out how to draw a line segment from one existing point to another existing point. If i can't do this, it will cost me $40 to get software that can.
The knoppix help menu was no help on this problem. Does anyone here know how to do this?
BTW: when i click on the "make line segment" button, it makes me make 2 new points to draw the line in. I want to be able to use the "make point at (x,y)" button twice, then draw a line between the two made points. My Constructions are simply too precise to use the mouse for all of it...
I just had a quick look at kGeo, it appears it may not be capable of doing what you want. Have a look at Qcad. It's actually a CAD drafting program but I think you can do lines entered from co-ordinate points with it.
Juniper Networks EX2300-C-12T Compact 12-Port EX2300-C Series Ethernet Switch
$300.00
Juniper Networks MX80-AC Router 4 Port XFP 10G MIC-3D-200E-SFP
$600.00
Juniper Networks EX3300-24P | 24 Port Gigabit Network Switch w/ Power cord
$53.99
Juniper Networks EX2200-C-12P-2G Gigabit Ethernet Managed Switch
$79.99
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$59.95
Juniper EX3400-48P 48-Ports PoE+ 4x SFP+ and 2x QSFP+ Managed Switch Tested
$135.00
Juniper EX2200-C-12T-2G 12-Port 10/100/1000 2x SFP Uplinks Compact Switch
$74.99
Juniper Networks SRX320-POE 6-Port Service Gateway Security Appliance Tested
$149.99
Juniper Networks EX4400-48MP 48 port 5GbE + 12 port 10 Gigabit PoE++ Switch -NEW
$1400.00
Juniper Networks EX2300-48P 48 Port Gigabit PoE 4 SFP 1/10G Network Switch
$185.00