I just had a quick look at kGeo, it appears it may not be capable of doing what you want. Have a look at Qcad. It's actually a CAD drafting program but I think you can do lines entered from co-ordinate points with it.
Ok, so KGEO might not be familiar to all of you, but it is the free alternative to a $40 progeam called Geometer's Sketchpad. I am homeschooled and woking on Geometry. Soon to do constructions, this software would be VERY useful.
I ran into a problem, however. I cannot figure out how to draw a line segment from one existing point to another existing point. If i can't do this, it will cost me $40 to get software that can.
The knoppix help menu was no help on this problem. Does anyone here know how to do this?
BTW: when i click on the "make line segment" button, it makes me make 2 new points to draw the line in. I want to be able to use the "make point at (x,y)" button twice, then draw a line between the two made points. My Constructions are simply too precise to use the mouse for all of it...
I just had a quick look at kGeo, it appears it may not be capable of doing what you want. Have a look at Qcad. It's actually a CAD drafting program but I think you can do lines entered from co-ordinate points with it.
Extron RGB-160XI Analog Computer Video 60-378-01
$187.06
The analog thing modern open source, educational, low-cost analog computer
$800.00
NEW Aquarius+ Computer Signature Edition - 8Bit Retro System
$229.00
Apple Macintosh SE/30 M5119 Computer 8MB RAM Recapped Working *See Description*
$475.00
IBM Modem Saver Phone Line Tester
$7.99
Landen Computer. Circa 1898. the Rapid Computer Company. With Original Case.
$425.00
NEW Aquarius+ Mini 8Bit Retro Computer System - Assembled PCB ONLY
$99.00
Soviet Union motherboard analog computer ZX Spectrum USSR
$97.00
ACASIS PCIE Capture Card HDMI 1.4 1080P60HZ PCIE 2.0 X4 20Gbps for Video Capture
$248.99
Sony Trinitron CPD-1304 9 PIN Analog Vintage CRT Monitor - Great for Retro PC
$475.30