I should clarify -- I can boot Knoppix just fine, but it can't see the SCSI hard disk so I can work on it.
Mojo
I'm running SuSE 9 (kernel 2.6) on a Dell Poweredge 1655MC blade server, and it runs just fine. I'm trying to boot Knoppix to resize the partitions and make disk images.
Knoppix fails attempting to load the SCSI module, mptbase:
mptbase: ioc0: ERROR - Diagnostic reset FAILED! (142h)
mptbase: ioc0: NOT READY WARNING!
mptbase: WARNING - ioc0 did not initialize property! (-1)
SuSE 9 is using the mptscsih module with no problems.
Any suggestions?
Best regards,
Mojo
I should clarify -- I can boot Knoppix just fine, but it can't see the SCSI hard disk so I can work on it.
Mojo
Nutanix NXS2U2NL12G500 2U Server with 2x X10DRT-P-G5-NI22 Blades USED
$349.99
Dell PowerEdge FX2s CTO Blade 4 Slot 2U Chassis 2x 2000W
$399.00
Dell PowerEdge FX2S 4 Slot Blade Chassis - CMC, 2x 2400W PSU
$299.00
Dell PowerEdge M620 Blade Server
$39.99
Dell PowerEdge M620 Blade Server 2 x Xeon e5 2665 8 x 16 GB(128) RAM - No HD
$44.99
Dell PowerEdge M620 Blade Server/8x8 GB Ram (64GB)/2x Intel Xeon E5-2680 2.70GH
$50.00
Dell PowerEdge M630 / HHB Server Module w 2x Intel E5-2680 & Dell P3V42 No HDD
$89.99
Supermicro SBI-7228R-T2X B10DRT-TP NO CPU RAM HDD Processor Blade Server CTO
$174.99
Dell PowerEdge M1000e Chassis w/ 16 x M600 Blade Servers(No Ram, 2 x 147GB HD)
$300.00
Cisco UCS B200 M4 Blade Server 2X E5-2697A V4 18C 2.60GHZ 512GB RAM No HD
$308.99