You need to reinstall and this time don't use IGNORE_CHECK=1.
Greetings,
I am very new to linux and recently installed the Knoppix 3.6 CD on a PC with success. So, I decided to install it on my laptop (HP Pavilion without a floppy drive) using the installer that comes with it. I used the IGNORE_CHECK=1 sudo knoppix-installer and when through the installation as I did with the PC. I chose the basic configuration and partitioned the whole hard drive for a single linux boot. Everything appeared to go well until it was time to remove the CD and reboot. I get the usual HP logo page and then I receive the following:
Hard disk boot sector invalid
Press 'H' to retry Hard Disk, any other key for floppy
Again, I don't have a floppy and selected "No" when it was offered during the installation.
What has happened and how do I get beyond this issue?
Thanks,
NEOMinds
You need to reinstall and this time don't use IGNORE_CHECK=1.
Cisco Meraki MX67-HW Firewall Security Appliance NEW
$284.99
Fortinet Fortigate FG-61E | Firewall Network Security Appliance
$49.99
Dell SonicWall TZ300 5-Port Network Security Firewall Appliance APL28-0B4
$24.95
Fortinet FortiGate FG-40F Network Security Firewall
$100.00
OPNsense six-port Gigabit router/firewall on Lanner FW-7535 hardware
$69.00
Palo Alto PA-220 Next-Gen Firewall 520-000309-00J w/ Power adapter
$69.98
Fortinet Fortiwifi 60D FG-60D Security Appliance Firewall / VPN w/ AC Adapter
$999.97
Dell SonicWALL TZ300 | Firewall Security Appliance
$24.99