In an attempt to cut the scream of my hdds, I tried disconnecting both ribbon cable and power cable from my hdds and booting with only cd-rom drives and Knoppix 3.3-2-19. Everything is detected without a problem, but ifconfig only shows the loopback info and netcardconfig fails the DHCP broadcast. lsmod has a zero to the right of the 3c59x module, which I assume means the module is unused.
Curiously, when I do nothing other than reconnect the ribbon cable and power cord to the hdd and boot back into Knoppix, lsmod shows a one where that zero was and ifconfig shows a successfully configured eth0 at int7. I'm a n00b, so I'm not sure what other info you need. Any ideas?
Thanks very much in advance.
Cisco ASA 5520 Adaptive Security Appliance
$56.75
PALO-ALTO NETWORKS PA-3050 SWITCH
$59.99
NetFu Firewall 1U, Intel CPU, 8 x Gigabit, SFP, w/ pfSense, Others, NEW OPTIONS
$541.85
Fortinet Fortigate FG-61E | Firewall Network Security Appliance
$49.99
Fortinet FortiGate FG-40F Network Security Firewall
$100.00
OPNsense six-port Gigabit router/firewall on Lanner FW-7535 hardware
$69.00
Fortinet Fortigate 70D Firewall Adapter Network Security Appliance
$52.00
Fortinet FortiGate 60E Network Security Firewall
$77.50
Fortinet Fortiwifi 60D FG-60D Security Appliance Firewall / VPN w/ AC Adapter
$999.97
Sophos XG 230 rev 1 Firewall Security Appliance with AC Adapter
$134.99