does knoppix correctly pick up your graphics card and support it? what type of graphics card do you have?
after knoppix runs through its intialization and tries to enter runlevel 5, my monitor shuts off. i can see everything until that point when it tries to start the GUI. i thought it was some ambiguous command in the startup that did it so i started knoppix in runlevel 2 and then tried to use the 'startx' command. it gets into the process of loading the gui, but the screen still shuts off. the cd continues to load the GUI into the memory though. help please.
does knoppix correctly pick up your graphics card and support it? what type of graphics card do you have?
Sometimes happens when the refresh rate is out of the monitors range.
try puting in the rates at boot
knoppix vsync=60 hsync=60 (examples)
yes, everything loads correctly, knoppix has no problem finding my graphics card or monitor. just after "X" loads, my screen wont come on.
have you tried what firebyrd10 said... thats mainly the next problem in line.
does it work now?
Cisco (SG100D-05-UK) 5-Ports External Ethernet Switch
$40.00
Cisco SG110 24 Port Gigabit Ethernet Switch w/ 2 x SFP SG110-24
$117.00
Cisco 110 SG110D-05 5 Ports Ethernet Switch - 1000Base-X SG110D-05-EU-WS
$40.00
Cisco SG95-16 16-Port Gigabit Switch SG95-16-SG
$47.00
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95
New Linksys SE3005 5-port Gigabit Ethernet Switch
$18.99
New 10/100 Mbps 8 Ports Fast Ethernet LAN Desktop RJ45 Network Switch Hub
$11.49
Linksys SE3008 8 Ports Rack Mountable Gigabit Ethernet Switch
$21.99
Fortinet FortiSwitch FS-124D-POE 24 Port Gigabit Ethernet Switch UNREGISTERED
$99.97
Netgear Prosafe Plus JGS524PE 24 Port Gigabit Switch 12 Port PoE JGS524PE-100NAS
$129.98