does knoppix correctly pick up your graphics card and support it? what type of graphics card do you have?
after knoppix runs through its intialization and tries to enter runlevel 5, my monitor shuts off. i can see everything until that point when it tries to start the GUI. i thought it was some ambiguous command in the startup that did it so i started knoppix in runlevel 2 and then tried to use the 'startx' command. it gets into the process of loading the gui, but the screen still shuts off. the cd continues to load the GUI into the memory though. help please.
does knoppix correctly pick up your graphics card and support it? what type of graphics card do you have?
Sometimes happens when the refresh rate is out of the monitors range.
try puting in the rates at boot
knoppix vsync=60 hsync=60 (examples)
yes, everything loads correctly, knoppix has no problem finding my graphics card or monitor. just after "X" loads, my screen wont come on.
have you tried what firebyrd10 said... thats mainly the next problem in line.
does it work now?
ACASIS 2.5/3.5 inch 2 Bay SATA USB 3.0 Hard Drive Disk HDD SSD Enclosure 4 RAID
$58.99
M.2 NVME SATA SSD Enclosure USB 3.2 Gen 2 10Gbps for M-Key or M+B Key SSD to 8TB
$40.86
SanDisk 2TB Ultra 3D NAND SSD, Internal Solid State Drive - SDSSDH3-2T00-G26
$149.99
Patriot P210 128GB 256GB 512GB 1TB 2TB 2.5" SATA 3 6GB/s Internal SSD PC/MAC Lot
$14.99
Intel DC S3510 Series 120GB SSD 2.5" 6Gb/s SATA Solid State Drive SSDSC2BB120G6K
$9.99
Netac 1TB 2TB 512GB Internal SSD 2.5'' SATA III 6Gb/s Solid State Drive lot
$13.99
Fanxiang SSD 512GB 1TB 2TB 4TB 2.5'' SSD SATA III Internal Solid State Drive lot
$13.99
Fanxiang 256GB 512GB 1TB 2TB 4TB Internal SSD 2.5" SATA III 6GB/s for PC/MAC Lot
$188.09
Fanxiang 4TB 2TB 1TB SSD 550MB/s 2.5'' SATA III Internal Solid State Drive lot
$209.99