I have seen HD installs lose network settings so I add a dhcp entry to /etc/network/interfaces
auto lo eth0
iface lo inet loopback
iface eth0 inet dhcp
Hello,
When i boot using the live CD (Knoppix 2.7) everything goes fine on my Dell D600. But When i install it on Hdd i loose network, usb support language (ok not so important this).
I have used knoppix-installer with the tow options in configuration : beginner and knoppix, and both have the same end ...
So how can i set the same configuration as with live CD auto config?
Or if you have a good tutorial
Thanks!
Scott
I have seen HD installs lose network settings so I add a dhcp entry to /etc/network/interfaces
auto lo eth0
iface lo inet loopback
iface eth0 inet dhcp
Part of the fun of linux is learning it. A few tweaks here and there and you will be right back to where you were. This is normal that a hd install does not have everything configured.
To get your network going try configuring the network card in the K menu-->knoppix-->network/internet-->network card configuration. Sometimes you have to do it more than once to get the connection started, at least with mine after a fresh install (dsl modem). Until you see auto lo eth0, that's when I know my network is up.
What type of usb support are you talking about?
The lang can be changed in the lilo.conf append line by changing the lang=de or whatever to lang=us if you want english. I think there is another place to change it but I never had to, the lilo.conf change was good enough. Hope this helps.
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco GLC-FE-100FX-RGD 100BASE-FX SFP Transceiver Module
$17.99
Cisco GLC-GE-100FX 100BASE-FX SGMII SFP Transceiver Module
$83.99
Cisco SFP-10/25G-CSR-S 10/25GBASE-CSR SFP28, 850nm, 100m, LC,
$54.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
10Gtek ASF-10G-T 10GBase-T 10GbE SFP+ to RJ-45 Copper Optical Transceiver Module
$35.99
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00