Hi,
I have two Notebooks, a Dell Latitude D600 and a Compaq Evo N160. On both systems I have installed Knoppix on the hard disk (Dell with Knoppix 3.6 and Compaq with Knoppix 3.4) as a Debian system. Both systems work fine, but when I try to make a presentation with our Beamer, the Beamer shows (independent of the notebook) just the middle part of the screen.
The reason seems to be, that the beamer gives DDC no signal about the resolution as I can see in the log-file of XFREE. As a result XFREE works in clone mode with a lower frequency (about 31.5 Mhz) on the beamer. When I start the notebooks connected with an external monitor who gives information about his resolution and afterwards swap the VGA cable with the one of the beamer everything works fine. Is there any chance to fix this problem in the X-configuration, so that I can connect to the beamer without going to clone mode?
Thanks
Dell PowerEdge FX2S FC830 Blade Server Chassis Enclosure 2*2000W PSU NO BLADES
$299.99
Dell PowerEdge M620 Blade Server 2x 10C E5-2690v2 64GB Ram 2x 600GB 10k HDD
$125.00
Dell PowerEdge FX2s CTO Blade 4 Slot 2U Chassis 2x 2000W
$399.00
HP ProLiant BL460c Gen9 Blade 2x E5-2690v4 2.6GHz =28 Cores 32GB P246 650FLB
$223.00
Dell PowerEdge M620 Blade Server 2 x Xeon e5 2665 8 x 16 GB(128) RAM - No HD
$44.99
Dell PowerEdge M520 Blade Server Xeon E5-2403 NO HDD NO RAM
$40.00
Dell PowerEdge FC830 8-SFF 4*Xeon E5-4669v3 2.1GHz No HDD/RAM Blade Server Node
$199.99
Dell PowerEdge M610 Blade Server E5620@2.2GHZ (6x)8GB RAM (2x)146GB 15K SAS HDD
$79.00
Dell PowerEdge C6320 82F9M Server Blade Module 10gb SFP+ 082F9M
$79.99
HP P17342-B21 M750 E2286M CTO BLADE SERVER
$269.95