Hi,
I have two Notebooks, a Dell Latitude D600 and a Compaq Evo N160. On both systems I have installed Knoppix on the hard disk (Dell with Knoppix 3.6 and Compaq with Knoppix 3.4) as a Debian system. Both systems work fine, but when I try to make a presentation with our Beamer, the Beamer shows (independent of the notebook) just the middle part of the screen.
The reason seems to be, that the beamer gives DDC no signal about the resolution as I can see in the log-file of XFREE. As a result XFREE works in clone mode with a lower frequency (about 31.5 Mhz) on the beamer. When I start the notebooks connected with an external monitor who gives information about his resolution and afterwards swap the VGA cable with the one of the beamer everything works fine. Is there any chance to fix this problem in the X-configuration, so that I can connect to the beamer without going to clone mode?
Thanks
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
HyperX FURY DDR3 8GB 16GB 32GB 1600 MHz PC3-12800 Desktop RAM Memory DIMM 240pin
$12.90
A-Tech 8GB PC3-12800 Desktop DDR3 1600 MHz Non ECC 240-Pin DIMM Memory RAM 1x 8G
$13.99
Samsung 128GB (4x 32GB) M86B4G70DM0-CMA3 PC3-14900L 4Rx4 DDR3 ECC Reg Server Mem
$39.99
Lot of 2 32GB DDR4 2666 PC4-21300 SODIMM RAM Modules Mixed Brand
$60.00
HyperX FURY RAM DDR4 16GB 8GB 32GB 4GB 3200 2666 2400 2133 Desktop Memory DIMM
$9.64
Kingston HyperX FURY DDR3 8GB 16GB 32G 1600 1866 1333 Desktop Memory RAM DIMM
$13.25
8GB PC3L-12800S 1600MHz SODIMM DDR3 RAM | Grade A
$12.00
A-Tech 256GB 4x 64GB 4Rx4 PC4-19200 ECC Load Reduced LRDIMM Server Memory RAM
$287.96
A-Tech 128GB 2x 64GB 4Rx4 PC4-19200 ECC Load Reduced LRDIMM Server Memory RAM
$143.98