--There is a FAQ about setting up Knoppix CD as FTP server:
http://sourceforge.net/docman/displa...group_id=70773
--Here also is my info:
http://www.knoppix.net/forum/viewtopic.php?t=362
Originally Posted by little sumo
As i use Knoppix as a rescue cd for various pc's, i tried to transfert files with a parallel cable.
So ,i set up a plip connection betwenn 2 pc's, they could ping each other, but i would like to transfer files with scp or something like (better with a GUI)
Thanks
--There is a FAQ about setting up Knoppix CD as FTP server:
http://sourceforge.net/docman/displa...group_id=70773
--Here also is my info:
http://www.knoppix.net/forum/viewtopic.php?t=362
Originally Posted by little sumo
Thanks for your reply, but my ftp settings seem to be ok: when i try a ftp seesion with eth0, there is no problem.
Is there a config where i should say ftp, to lesson on plip0 instead of eth0?
Regards.
--Hmm... Sounds like a routing issue to me, and route commands are beyond my ken.
Originally Posted by little sumo
Dell PowerEdge FX2S 4 Slot Blade Chassis - CMC, 2x 2400W PSU
$299.00
Nutanix NXS2U2NL12G500 2U Server with 2x X10DRT-P-G5-NI22 Blades USED
$349.99
Dell PowerEdge M620 Blade Server
$39.99
Dell PowerEdge FX2s CTO Blade 4 Slot 2U Chassis 2x 2000W
$399.00
Dell PowerEdge M620 Blade Server 2 x Xeon e5 2665 8 x 16 GB(128) RAM - No HD
$44.99
Dell PowerEdge M620 Blade Server/8x8 GB Ram (64GB)/2x Intel Xeon E5-2680 2.70GH
$50.00
Dell PowerEdge M630 / HHB Server Module w 2x Intel E5-2680 & Dell P3V42 No HDD
$89.99
Dell PowerEdge M520 Blade Server Xeon E5-2403 NO HDD NO RAM
$40.00
Dell PowerEdge FC830 8-SFF 4*Xeon E5-4669v3 2.1GHz No HDD/RAM Blade Server Node
$179.99
Dell PowerEdge M1000e Chassis w/ 16 x M600 Blade Servers(No Ram, 2 x 147GB HD)
$300.00