My 3COM 3C940 NIC is not detected by hwsetup.

Hwsetup -v -n tells me:
class: NETWORK
bus: PCI
device: eth
driver: unknown
desc: 3Com Corporation|unknown device 10b7:1700
lspci -vvv tells me:
0000:00:09.0 Ethernet controller: 3Com Corporation 3c940 10/100/1000Base-T [Marvell] (rev 12)
Subsystem: Asustek Computer, Inc. P4P800 Mainboard
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 32 (5750ns min, 7750ns max), Cache Line Size: 0x08 (32 bytes)
Interrupt: pin A routed to IRQ 5
Region 0: Memory at ec800000 (32-bit, non-prefetchable) [size=16K]
Region 1: I/O ports at d800 [size=256]
Capabilities: [48] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=1 PME-
Capabilities: [50] Vital Product Data
The network card works if I install the module 'sk98lin'.
Probably this would be solved if hwsetup would be told to use sk98lin for this PCI ID.