-
linux26 locks up when creating fstab
I am trying to get linux26 booting on an abit BE6 system. 2.4 boots fine without any issues. Booting up with linux26 locks up at the message scanning drives to create /etc/fstab. I am able to by pass this by specifying nodma. The drives are too slow without DMA.
When enabling DMA, I get DMA Timeout Error 0x21.
The BE6 motherboad has an onboard highpoint 366 dma controller in addition to the bx chipset ide controller. I have already updated the bios to the latest version. Is these a known issue with this board and 2.6? I have tried a couple differen knoppix versions and they all have this same problem. Is there a way I can use the expert boot to use a different driver for the onboard highpoint controller?
I discovered this using the Knoppmyth installation CD, but then experienced the same issue with Knoppix 3.6 and 3.4.
Any help would be great.
Here is lspci -v in 2.4:
00:00.0 Host bridge: Intel Corp. 440BX/ZX/DX - 82443BX/ZX/DX Host bridge (rev 03)
Flags: bus master, medium devsel, latency 32
Memory at d0000000 (32-bit, prefetchable) [size=64M]
Capabilities: [a0] AGP version 1.0
00:01.0 PCI bridge: Intel Corp. 440BX/ZX/DX - 82443BX/ZX/DX AGP bridge (rev 03) (prog-if 00 [Normal decode])
Flags: bus master, 66Mhz, medium devsel, latency 64
Bus: primary=00, secondary=01, subordinate=01, sec-latency=32
I/O behind bridge: 00009000-00009fff
Memory behind bridge: d4000000-d7ffffff
00:07.0 ISA bridge: Intel Corp. 82371AB/EB/MB PIIX4 ISA (rev 02)
Flags: bus master, medium devsel, latency 0
00:07.1 IDE interface: Intel Corp. 82371AB/EB/MB PIIX4 IDE (rev 01) (prog-if 80 [Master])
Flags: bus master, medium devsel, latency 32
I/O ports at f000 [size=16]
00:07.2 USB Controller: Intel Corp. 82371AB/EB/MB PIIX4 USB (rev 01) (prog-if 00 [UHCI])
Flags: bus master, medium devsel, latency 32, IRQ 9
I/O ports at a000 [size=32]
00:07.3 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ACPI (rev 02)
Flags: medium devsel, IRQ 9
00:09.0 Multimedia audio controller: Ensoniq ES1370 [AudioPCI]
Subsystem: Unknown device 4942:4c4c
Flags: bus master, slow devsel, latency 32, IRQ 9
I/O ports at a400 [size=64]
00:0d.0 Ethernet controller: Linksys Network Everywhere Fast Ethernet 10/100 model NC100 (rev 11)
Subsystem: Linksys: Unknown device 0574
Flags: bus master, medium devsel, latency 32, IRQ 9
I/O ports at a800 [size=256]
Memory at dd000000 (32-bit, non-prefetchable) [size=1K]
Expansion ROM at <unassigned> [disabled] [size=128K]
Capabilities: [c0] Power Management version 2
00:0f.0 Multimedia video controller: Internext Compression Inc: Unknown device 0016 (rev 01)
Subsystem: Hauppauge computer works Inc.: Unknown device 4009
Flags: bus master, medium devsel, latency 64, IRQ 10
Memory at d8000000 (32-bit, prefetchable) [size=64M]
Capabilities: [44] Power Management version 2
00:13.0 Unknown mass storage controller: Triones Technologies, Inc. HPT366/368/370/370A/372 (rev 01)
Flags: bus master, medium devsel, latency 120, IRQ 11
I/O ports at ac00 [size=8]
I/O ports at b000 [size=4]
I/O ports at b400 [size=256]
Expansion ROM at <unassigned> [disabled] [size=128K]
00:13.1 Unknown mass storage controller: Triones Technologies, Inc. HPT366/368/370/370A/372 (rev 01)
Flags: bus master, medium devsel, latency 120, IRQ 11
I/O ports at b800 [size=8]
I/O ports at bc00 [size=4]
I/O ports at c000 [size=256]
01:00.0 VGA compatible controller: ATI Technologies Inc Rage Mobility P/M AGP 2x (rev 64) (prog-if 00 [VGA])
Subsystem: ATI Technologies Inc Rage Mobility P/M AGP 2x
Flags: bus master, stepping, medium devsel, latency 32, IRQ 10
Memory at d4000000 (32-bit, non-prefetchable) [size=16M]
I/O ports at 9000 [size=256]
Memory at d6000000 (32-bit, non-prefetchable) [size=4K]
Expansion ROM at <unassigned> [disabled] [size=128K]
Capabilities: [50] AGP version 1.0
Capabilities: [5c] Power Management version 1
Similar Threads
-
By HansB in forum German Forum
Replies: 2
Last Post: 02-12-2006, 11:45 AM
-
By nikgik in forum Hardware & Booting
Replies: 0
Last Post: 01-16-2006, 01:22 PM
-
By raydance in forum General Support
Replies: 1
Last Post: 12-23-2004, 09:40 PM
-
By xyzzy in forum General Support
Replies: 2
Last Post: 05-14-2004, 06:13 PM
-
By niyogi in forum General Support
Replies: 5
Last Post: 08-17-2003, 11:53 PM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
SQL Server 2019 Standard (10 CAL) - Windows and Linux, Physical License NEW
$178.45
Microsoft SQL Server 2019 Standard (10 CAL) Windows, Linux Physical License, NEW
$178.99
SQL Server 2019 Standard (10 CAL) - Windows and Linux, Physical License
$215.26
IBM X3200 M3 Tower Server Intel Xeon X3450 2.67GHz 2GB 2*500 Gb Hdd Linux AS IS
$60.00
IBM E850 Power8 2x 12C 3.02GHz 512Gb 1.8Tb SAS 10GbE 16Gb Linux Server 8408-E8E
$699.95
NEW Redhat Enterprise Linux 7 Server Edition (Factory Sealed)
$25.00
Custom Laptop, Desktop or Server Badge - Set of 12 (Select your Linux distro)
$5.45
1U Server 15" Depth X11SSH-F E3-1270 V6 3.8Ghz 4 Core 32GB RAM 240G SSD
$250.00
Linux Multi-Boot USB Installer 13-in-1 | Dual USB-A & USB-C | Ubuntu, Mint, Etc
$19.99
1U BareMetal pfsense opnsense Router Firewall DNS Server 6x 10GB Ethernet Ports
$169.00