I recently installed knoppix v3.9 on my sony vaio laptop. The GUI loaded just fine for the first 4 or 5 boots and
then all of the sudden, no GUI just manual prompt. I logged in and tried using startx to load the GUI but it just gives me errors.
Is there another command to load the GUI? This happened on my Dell Laptop as well and i just rebooted 10-15 times and it finally it gave me the GUI again.
Computer is a:
Sony Vaio PCG-F610
Mobile AMD k6-2 550 Mhz
128MB ram
I did alot of searching and all i found was that you should edit your XF86Config file and set your
vertical and horizontal refresh rates manually. Still doesnt explain the fact that it booted into the GUI
at once, and then all of the sudden stopped.
Dell PowerEdge R720 Server - 2x8c CPU,256Gb RAM, 128Gb SSD/3x900Gb SAS, Proxmox
$340.00
HP ProLiant DL360 G9 Server | 2 x E5-2660V3 2.6Ghz | 64GB | 2 x 900GB SAS HDD
$339.00
H261-Z61 2U 24SFF AMD Server 8x EPYC 7551 256-Cores 256GB RAM 8x25G NIC 2x2200W
$2612.18
Dell PowerEdge R730 8 SFF 2x E5-2660 v4 28 Cores 128/256GB 0/3x 900GB 6Gbps H730
$349.99
Dell PowerEdge R730XD 28 Core Server 2X Xeon E5-2680 V4 H730 128GB RAM No HDD
$389.99
Dell PowerEdge R620 Server 2x E5-2660 v1 2.2GHz 16 Cores 256GB RAM 2x 300GB HDD
$79.19
HP Proliant DL360 Gen9 28 Core SFF Server 2X E5-2680 V4 16GB RAM P440ar No HDD
$196.95
Dell PowerEdge R720XD Xeon E5-2680 V2 2.8GHz 20 Cores 256GB RAM 12x4TB
$510.00
HP ProLiant DL380 Gen9 16SFF 2x E5-2680v4 2.4GHz =28 Cores 64GB P840 4xRJ45
$353.00
DELL R730XD Server 2x E5-2680v4 2.4GHz =28 Cores 128GB H730 4x 1.2TB SAS 4xRJ45
$504.00