hi
I am new to Knoppix but not linux. I can start Knoppix on my PC with the CD or DVD fine.
I use "K->KNOPPIX->Configure->Create a persistent KNOPPIX disk image" to
create a disk image (100MB) on my /dev/sda7 (empy 37G partition ext2 formated),
I can see the knoppix.img created. If I make some change (wall paper, 'touch ~/foo')
then reboot with "knoppix home=/dev/sda7" or "knoppix home=scan" I don't
see my changes re-appear. (nor do I see the blue screen with multiple choice box
that lets me select "system" during start up) why? I assume the disk image I created wasn't used.
To be sure I made the changes again and created a new image after the changes then reboot
again. I still don't see the changes. Then I tried to make the image on a USB
stick. It *works* with "knoppix home=scan" but *not* with "knoppix home=/dev/sdb1".
Why?
How do I check if the disk image is used? and if the image is not being used, what is wrong?
by the way I can use K->KNOPPIX->Configure->Save KNOPPIX Configuration to to save
config changes on a USB stick. From what I understood, this and the disk image are two separate
things. no?
can anyone tell me what the problem is? thanks
Cisco Catalyst 3650 48-Port Managed PoE+ Gigabit Switch WS-C3650-48FS-E
$55.99
Cisco Nexus 48-Port 10G SFP+ Switch N9K-9396PX w/ 9K-M12PQ 12-Port 40G QSFP
$249.99
Cisco 24-Port Managed Gigabit Switch WS-C3750G-24TS-S
$49.99
Cisco IE-3000-8TC Industrial Ethernet 8 Ports Managed Switch 1 Year Warranty
$114.00
New Linksys SE3005 5-port Gigabit Ethernet Switch
$18.99
New 10/100 Mbps 8 Ports Fast Ethernet LAN Desktop RJ45 Network Switch Hub
$11.49
NETGEAR GS308 8 Gigabit Port Unmanaged Ethernet Switch with Power Cord
$12.95
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95
Netgear ProSafe S3300-52X-POE+ 48-Port Gigabit PoE+ Stackable Network Switch
$100.95
Netgear Prosafe Plus JGS524PE 24 Port Gigabit Switch 12 Port PoE JGS524PE-100NAS
$129.98