I have the same problem
It says Initializing Modem but nothing happens
I have Connexant soft 56 K Internal modem
I'm newbie for Linux and Dial Up user..
I've tried to configure my internal 56K modem (ActionTec V.90 PCI Modem) via the modem-assistant. I know my modem not winmodem, it's hardware modem And It use COM PORT=3, IRQ=9 on WinXP)
However it can't find with S2.. I get an answer from the modem on S1 but empty ATI Values.
Anyway, if I dial, the modem stops on "initializing modem".
What's the Problem?
And what can i do?
Thanks in advance..
I have the same problem
It says Initializing Modem but nothing happens
I have Connexant soft 56 K Internal modem
FarAway- as root do this:
setserial /dev/ttyS3 irq 9
ln /dev/ttyS3 /dev/modem
Then configure kppp
Cisco GLC-FE-100FX-RGD 100BASE-FX SFP Transceiver Module
$17.99
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco SG110 24 Port Gigabit Ethernet Switch w/ 2 x SFP SG110-24
$117.00
Cisco GLC-GE-100FX 100BASE-FX SGMII SFP Transceiver Module
$83.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
10Gtek ASF-10G-T 10GBase-T 10GbE SFP+ to RJ-45 Copper Optical Transceiver Module
$35.99
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95