to install grub to the master boot record: grub-install /dev/hda
I just finished the default knoppix 4.0.2 installation.
I'm told I should use grub-install because the I can specify "lang=us dma" in the configuration file. I've been reading http://orgs.man.ac.uk/documentation/grub/grub_16.html but I cannot figure out what to specify for the required device parameter.
I try grub-instal hda0 and it says "format of installed device not recognized".
I try grup-install hd0 (as exemplified in the documentation) and it says "Could not find device for /boot: Not found or not a block device."
I try "grub-install hda" and it says "Format of install_device not recognized."
I try "grub-install /dev/hda1" and it says "Could not find device for /boot: Not found or not a block device."
Thanks,
Siegfried
knoppix@0[knoppix]$ sudo fdisk -l
Disk /dev/hda: 40.0 GB, 40007761920 bytes
255 heads, 63 sectors/track, 4864 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System
/dev/hda1 * 1 6 48163+ 83 Linux
/dev/hda2 7 4767 38242732+ 83 Linux
/dev/hda3 4768 4864 779152+ 82 Linux swap / Solaris
knoppix@0[knoppix]$
to install grub to the master boot record: grub-install /dev/hda
JUNIPER ELECTRONICS NFX250-ATT-LS1
$250.00
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$37.24
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$59.95
Juniper EX3300-48P 48-Port 10/100/1000BASE-T (48 PoE+ ports) with 4 SFP+
$74.00
Juniper EX3300-48P, 48 Port PoE+ Gigabit Network Switch with RACK EARS, RESET
$46.99
Juniper EX2300-48P 48-Port Gigabit Ethernet Switch PoE+ 4x SFP+ Power Cable
$104.40
Juniper EX4200-48PX 48-PORT 10/100/1000BASET PoE Ethernet Switch
$38.87
JUNIPER EX4200-24PX 24-Port Gigabit PoE+ Managed Ethernet Network Switch
$49.95
Juniper Networks EX2300-C-12T Compact 12-Port EX2300-C Series Ethernet Switch
$300.00
JUNIPER SRX340 SERVICE GATEWAY APPLIANCE Tested/Working #73
$111.99