ahhhahah same problem here i u figure it out tell me!!!!
I am using auditor which is built on knoppix and I am having problems putting my MA401 into monitor mode.
here is what I use:
iwconfig wlan0 monitor mode
error message I get:
Error for wireless request "set mode" (8B06) :
SET failed on device wlan0 ; operation not supported.
ahhhahah same problem here i u figure it out tell me!!!!
there is a thread on this on linuxquestions.org
did it work for you?, if so what thread helped you?
Hello,
"su" to root and iwconfig eth* mode monitor should work for you.
So, in your case, at the command line "su" , then enter root password if any.
Then do "iwconfig wlan0 mode monitor" , note the correct syntax, and without colons.
Br,
MrBean
Juniper Networks 740-061405 JNP-QSFP-100G-SR4 OM3 QSFP28 100GE 850nm100m 1PCS
$150.00
Factory new Sealed SRX-GP-16GE-PoE Juniper Networks expansion module
$79.00
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$40.10
Juniper Networks EX4300-48T 48 Port Gigabit 4 QSFP 40G 2xPSU AFO Network Switch
$89.00
JUNIPER EX3400-48P 48x 1GB PoE+ RJ-45 4x 10GB SFP+ 2x 40GB QSFP+, DUAL AC POWER
$210.00
Juniper QFX5100-48S-3AFO Switch 48 x 10Gb SFP+, 6x QSFP 40GE, Dual AC Power
$499.00
Juniper Networks EX2300 -24P 24 Port Gigabit PoE Network Switch
$149.00
New Factory Sealed Juniper EX2300-48P Networks 48-Port Managed Ethernet Sealed
$499.00
Juniper EX2300-48P PoE+ Switch 48x 1GbE & 4 SFP+/SFP 10G uplinks, Tested
$289.00