Hi,
I'm using qtparted from the Knoppix CD because I want to shrink the NTFS partition on my Windows laptop, so that I can install Fedora to give me a dual-boot system.
When I tried running qtparted yesterday it showed me the two existing partitions on my disk. Unfortunately when I tried to resize one it said that it was in use. I got the idea to run "chkdsk /f" from another forum to resolve this problem.
But now when I run qtparted it doesn't pick up my hard drive at all - the only disk it sees is "/UNIONFS/dev/hdc", which I assume is my CD-ROM drive.
I guess the fact that I ran chkdsk may be unrelated, but I can't think of anything else I've done that could prevent qtparted from seeing my hard disk.
Any ideass?
Cisco Catalyst C9300-24UX-A 24 Port 10G/mGig Copper UPOE Network Switch
$475.00
Cisco 3560CG Series 8 Port POE Network Switch WS-C3560CG-8PC-S
$80.00
Cisco WS-C2960X-48FPD-L 48 V07 POE+ GE+2 10G SFP+, LAN BASE 740W w/ C2960X-Stack
$140.00
Cisco 2900 Series CISCO2901/K9 v06 Integrated Services Router
$39.99
🔥🔥🔥 CISCO SFP-10G-SR V03 10-2415-03 850nm 10GBASE-SR SFP+ Multi Module 🔥🔥🔥
$6.80
GENUINE Cisco SFP-10G-SR V03 SFP+ GBIC Transceiver Module 10-2415-03
$6.80
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$30.99
Cisco SFP-10G-SR 10-2415-03 10 Gigabit Transceiver LOT OF 10 @ C
$39.99
Cisco WS-C3560CX-12PC-S 12 Port GbE PoE IP Base Catalyst Managed Switch, TESTED
$174.00
Cisco WS-C3850-12X48U-S 48x (12x MultiGB) UPoE RJ-45 1x Mod Slot Switch, Tested
$259.00