-
hard drive partitioning error
Wow I'm sure evryone is pumped to see another newbie posting an issue about a hard drive partioning debacle
here's my issue:
I am trying to install knoppix 4.0.2 onto my hard drive
i ran sudo knoppix-installer
hard drive rqmn'ts were not met
i HAD one big primary partition formated as an ntfs
i deleted it using qtparted and commited...
then i tried to create one big extended partition containing 4 logical drives...i marked the first as bootable
after committing i rebooted and now i am unable to access the /dev/hda using qtparted, cfdisk, or fdisk
critical error when trying to read the partition table with any of these programs....
have i rendered my hard drive useless??
if not...how can i start over??
-
Administrator
Site Admin-
I doubt very much that your hard drive is useless, although that nasty ntfs partition may well be gone.
There is really no reason to use all of the drive for only an extended partition, I would certainly suggest creating some real partitions there and only making an exteded partition if you are going to run out of physical partitions, which you would not as you described things.
As to tools to use, they depend somewhat on what you plan to do with that hard disk. qtparted is a problem for many (I don't use it so can't really give advice on it). There are other partitioning tools that you could try, including the fdisk on Knoppix. Personally I wuld use Ranish from Windows or even a DOS floppy, but that's just because I like Ranish. And if the goal is to get Linux installed and bootable from the hard disk then I would just use the tools in the Etch hard disk network installer. If you are asking how to install Knoppix to this hard disk, sorry, that is a mistake that I don't help people make.
-
Administrator
Site Admin-
Also, if you have an old bootable DOS floppy around you might try the fdisk on that. And you may need the special command fdisk /mbr to repair the master boot record. Beyond that I'm not clear on why fdisk in Knoppix can't see the hard disk, but be sure to try a complete power down and the reboot Knoppix, don't just try using fdisk in the same Knoppix session after using qtparted.
---
Verifying of md5 checksum and burning a CD at slow speed are important.
Similar Threads
-
By cha0sunity in forum Hardware & Booting
Replies: 2
Last Post: 03-04-2010, 11:34 PM
-
By cmj33875 in forum Hardware & Booting
Replies: 3
Last Post: 11-01-2009, 01:31 AM
-
By vierdreieins in forum MS Windows & New to Linux
Replies: 7
Last Post: 11-11-2006, 05:52 AM
-
By bread in forum General Support
Replies: 3
Last Post: 02-27-2006, 04:27 AM
-
By jc01 in forum Hdd Install / Debian / Apt
Replies: 2
Last Post: 09-29-2003, 03:02 AM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
MacEffects Gray ALPS Mechanical Keyboard for Vintage Apple IIe Computers
$195.00
Vintage Apple Keyboard II M0487 Untested No ADB Cable
$30.00
Vintage Apple IIC Monitor stand A2M4021 with Hinge Complete Tested Works Great
$109.99
Vintage Macintosh Classic Case Apple asset tag
$50.00
Vintage Apple Certifited Apple Technical Coordinator T Shirt
$35.00
Vintage Apple Extended Keyboard II Vintage
$35.00
Vintage Apple Ethernet Twisted-Pair Transceiver Model M0437
$19.99
VINTAGE APPLE 1980’s COMPUTER LAPEL PIN BADGE
$14.99
Vintage Apple Newton MessagePad 2000 With Original Box and Some Accessories
$199.99
Apple Macintosh Performa 466 Vintage Computer | SKU 146754
$149.95