The CD goes through its normal booting process until it gets to the point where it scans for hard drive and partition info, and creates /etc/fstab.
The /etc/fstab part completes, but then my system will immediately go to a cursor and stop booting
The only way to get around it is to run in failsafe mode, which bypasses damn near everything, including my hard drive
I ran 'knoppix testcd' and it came back without any errors, it just always stops in that one spot.
Edit: Problem solved, i had to use the 'knoppix dma' cheatcode. (also, why cant we delete our own posts?)
DELL Hard Drive SATA 6 Gbps 8TB 512e RPM 7.2K - MG05ACA800E
$29.99
HITACHI HUS724040ALA640 4TB 7200RPM 64MB SATA 6.0Gb/s 3.5" HARD DRIVE ZERO HOURS
$52.00
Seagate ST1000VM002 1TB 64MB SATA6Gb/s 3.5" (Low Power) Hard Drive -PC, CCTV DVR
$24.99
WD Ultrastar DC HC520 12TB SATA III 3.5" Enterprise HDD (HUH721212ALE600)
$100.00
HGST Ultrastar DC HC520 12TB SATA 6Gb 256MB 3.5" Enterprise HDD- HUH721212ALE601
$74.99
CISCO A03-D1TBSATA 1TB 7.2K 6G 2.5INCH SATA HDD
$9.00
Seagate ST12000NM0127 12TB SATA 6Gb/s 256MB 7200RPM 3.5" Enterprise Hard Drive
$99.99
WD Ultrastar DC HC530 14TB SATA 6G 3.5" 7200RPM Enterprise HDD - WUH721414ALE604
$110.00
Seagate ST8000NM0055 8TB 7200RPM 256MB SATA 6.0 Gb/s 3.5" Enterprise Hard Drive
$41.62
Western Digital 4TB Internal 7.2KRPM 3.5" (WD4000FYYZ) SATA Hard Drive ZERO HOUR
$69.99