The CD goes through its normal booting process until it gets to the point where it scans for hard drive and partition info, and creates /etc/fstab.
The /etc/fstab part completes, but then my system will immediately go to a cursor and stop booting
The only way to get around it is to run in failsafe mode, which bypasses damn near everything, including my hard drive
I ran 'knoppix testcd' and it came back without any errors, it just always stops in that one spot.
Edit: Problem solved, i had to use the 'knoppix dma' cheatcode. (also, why cant we delete our own posts?)
Cisco ASA5506-K9 ASA 5506-X Network Security Firewall
$40.00
Fortinet Fortigate FG-61E Firewall Network Security Appliance ATP Bundle 1 years
$263.99
Fortinet FortiGate 60F | 10 Gbps Firewall Network Security EXPIRED (FG-60F)- New
$226.79
Cisco ASA 5506-X Network Security Firewall w/ AC Adapter
$39.99
Fortinet Fortigate-61e Security Firewall Appliance No AC Adapter/SSD
$44.99
Fortinet FortiWiFi-60E Network Security Appliance - White
$38.40
pfSense Firewall VPN AES-NI Celeron N3350 1.10GHz 6GB RAM 80GB SSD 5x Intel NIC
$81.00
Sophos SG-115 Rev 2 UTM Firewall Security Appliance 4-Port - Untested
$34.99
Palo Alto Networks PA-850 Firewall VPN Gateway w/ Rack Ears and Dual PSU
$194.99
Cisco ASA 5516-X Adaptive Security Firewall Appliance Network Device
$249.99