gconftool was added for Gnome-based distributions such as Ubuntu, but klik should continue to work fine without it.
I had used Klik numerous times prior to about a month ago, when attempts to install the script as per instructions began to be interrupted by:
sh: line 571: gconftool-2: command not found
I am running Knoppix 4.02, as I was when Klik formerly worked. Have you altered the script to include sw not on Knoppix? I get the same result when running Knoppix 5.0.
Thanks for any help.
gconftool was added for Gnome-based distributions such as Ubuntu, but klik should continue to work fine without it.
You can safely ignore the gconftool-2 message. klik works anyway.
HITACHI HUS724040ALA640 4TB 7200RPM 64MB SATA 6.0Gb/s 3.5" HARD DRIVE ZERO HOURS
$52.00
Western Digital 4TB Internal 7.2KRPM 3.5" (WD4000FYYZ) SATA Hard Drive ZERO HOUR
$69.99
Seagate ST1000VM002 1TB 64MB SATA6Gb/s 3.5" (Low Power) Hard Drive -PC, CCTV DVR
$24.99
Western Digital Gold Enterprise 4TB,7200 RPM Internal Hard Disk Drive WD4002FYYZ
$39.95
HGST Ultrastar DC HC520 12TB SATA 6Gb 256MB 3.5" Enterprise HDD- HUH721212ALE601
$74.99
CISCO A03-D1TBSATA 1TB 7.2K 6G 2.5INCH SATA HDD
$9.00
Seagate ST12000NM0127 12TB SATA 6Gb/s 256MB 7200RPM 3.5" Enterprise Hard Drive
$99.99
WD Ultrastar DC HC530 14TB SATA 6G 3.5" 7200RPM Enterprise HDD - WUH721414ALE604
$110.00
Hitachi 4TB 3.5" Hard Drive HUS724040ALE640 Ultrastar 7K4000 Internal 7.2K
$49.95
WD 4TB Gold Enterprise - 7200 RPM SATA 6Gb/s 128MB CACHE 3.5" HDD - WD4002FYYZ
$42.95