gconftool was added for Gnome-based distributions such as Ubuntu, but klik should continue to work fine without it.
I had used Klik numerous times prior to about a month ago, when attempts to install the script as per instructions began to be interrupted by:
sh: line 571: gconftool-2: command not found
I am running Knoppix 4.02, as I was when Klik formerly worked. Have you altered the script to include sw not on Knoppix? I get the same result when running Knoppix 5.0.
Thanks for any help.
gconftool was added for Gnome-based distributions such as Ubuntu, but klik should continue to work fine without it.
You can safely ignore the gconftool-2 message. klik works anyway.
$500.00
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$359.99