Hello,
I recently installed two different copies of Knoppix 5.0.1, but in neither of them I am been able to start vncserver.
I tried with version 3.3 and 4.0 of vncserver, but I have the same problem: Could not open font "fixed"
22/10/06 10:35:53 Xvnc version 3.3.7 - built Aug 9 2006 08:33:03
22/10/06 10:35:53 Copyright (C) 2002-2003 RealVNC Ltd.
22/10/06 10:35:53 Copyright (C) 1994-2000 AT&T Laboratories Cambridge.
22/10/06 10:35:53 All Rights Reserved.
22/10/06 10:35:53 See http://www.realvnc.com for information on VNC
22/10/06 10:35:53 Desktop name 'X' (ADDRESS:2)
22/10/06 10:35:53 Protocol version supported 3.3
22/10/06 10:35:53 Listening for VNC connections on TCP port 5902
Fatal server error:
could not open default font 'fixed'
Any ideas?
I also tried to install also xfs and xfs-tt and configure the vnc.conf accordingly, but no result.
Marco.
Altair 8800 CPU Board Working *TESTED* reproduction
$790.00
MITS ALTAIR 8800 B Original Vintage Microcomputer
$5250.00
MITS ALTAIR 8800 Vintage Computer w/ Keyboard, Floppy, boards - Buy It Now
$9275.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
Cromemco Assembler / ROS Paper Tape - 1977 Altair IMSAI
$79.99
Cromemco Z-80 Monitor v1.0 Paper Tape - 1976 Altair IMSAI
$79.99
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
IMSAI 8080A MPU-A CPU Parts Kit Not Altair MITS (board NOT included)
$59.95
Altair MSAI Douglas Electronics 11 DE Prototype Card S100 circuit board #AX44
$69.00
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00