I'm trying to setup a demo/test system using Knoppix 5.01. The system is a Dell PowerEdge 1650. I've turned off the local hard drives in the BIOS, and have installed a QLA2200 1Gb FC card to attach to our SAN. It seems to recognize the card, but when the driver loads, we get the following messages in dmesg:
Qlogic Fibre Channel HBA Driver
ACPI: PCI Interrupt 0000:03:08.0[A] -> GSI 20 (level, low) -> IRG 16
qla2xxx 0000:03:08.0: Found an ISP2200, irq 16, iobase 0xf886a000
qla2xxx 0000:03:08.0: Configuring PCI space...
qla2xxx 0000:03:08.0: Configure NVRAM parameters...
qla2xxx 0000:03:08.0: Verifying loaded RISC code...
qla2xxx 0000:03:08.0: Firmware image unavailable.
qla2xxx 0000:03:08.0: Failed to initialize adapter
Any ideas? Is there a way to manually load the driver with modprobe after boot time that might work around this?
ASUS H310M-A R2.0 ATX LGA1151 DDR4 Desktop Motherboard USB 3.0 w/ I/O Shield
$39.99
Gigabyte Z370P D3 ATX Z370 LGA1151 Motherboard (Support Intel 6/7th 8th 9th)
$59.99
ASRock B550M Pro SE AM4 DDR4 SATA 6Gb/s 1 PCIe 4.0 x16 Micro ATX Motherboard
$84.99
Asus H81M-C Intel LGA1150 DDR3 Desktop Motherboard MicroATX Socket H3
$23.99
ASUS H110M-R Motherboard Intel 6th/7th Gen LGA1151 DDR4 Micro-ATX i/o shield
$42.00
Asus Prime H310M-A R2.0 Intel LGA 1151 DDR4 Desktop Motherboard
$54.99
Asus H110M-K LGA 1151 DDR4 USB 3.0 Micro ATX Intel Desktop Motherboard w/IO
$34.95
NEW OEM ASRock H410M/MC LGA1200 Intel M-ATX Motherboard (Wifi)
$49.99
Gigabyte M-ATX motherboard with Intel Core i3 8100 CPU and 8GB DDR4 RAM
$84.00
ASUS PRIME Z690-P WIFI D4 ATX Motherboard Intel LGA1700 DDR4 HDMI
$99.99