I'm not a networking expert but think its stored under
/etc/init.d/networking
Hi all,
I am installing Gentoo, and using Knoppix to kick-start the install. I have managed to get to the point where I have to define all of the Networking Configuration in Gentoo. In Gentoo, according to the Install Handbook, everything is stored in /etc/conf.d/net. Unfortunately, Knoppix does not have an /etc/conf.d.My question is: where do I look in Knoppix for hints and how do I translate that into Gentoo-speak for all Networking.
Also important: I am currently installing on a box that is connected "directly to the Internet", through DHCP. I expect this one to be easy, as Knoppix detects everything without any trouble or input from me. I will be later doing this on a second box, where I first (under Knoppix) need to run the ADSL/PPPOE configuration - which works fine after I answer Yes to all questions, but where are the "results" stored.
Thank You.
I'm not a networking expert but think its stored under
/etc/init.d/networking
In case anyone is reading this, I found the answer to my question: the settings between the two are not compatible.Fortunately, Gentoo is well documented!
![]()
Cisco WS-X4712-SFP+E Catalyst 4500 Series Line Card 10GbE 12-Port Module SFP+
$59.00
For Cisco SFP-10G-T, Ubiquiti UF-RJ45-10G Transceiver, SFP+ to RJ45 10GBase-T
$40.99
XGS-PON ONU SFP+ Stick MAC SC/APC 1270/1577nm -40 to 85°C 10G/10G XGSPON ONT
$199.99
Cisco SFP-10G-SR SFP Transceiver Module
$13.00
INTEL 10G SFP+ SR SFP E10GSFPSR FTLX8571D3BCV-IT For X520-DA2 X520-SR2 X710-DA2
$9.49
🔥🔥🔥Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver 10-2415-03 🔥🔥🔥
$8.00
Cisco SFP-10G-SR 10-2415-03 10 Gigabit Transceiver LOT OF 8
$24.00
Lot of 10 Cisco SFP-10G-SR 10-2415-03 V03 10GBase-SR 850nmSFP+Transceiver Module
$34.95
Dell X1018 X-Series Smart Managed Switches 16-Port Gigabit 2-Port SFP Switch
$45.00
For Cisco SFP-10G-T-X Transceiver Multi-Rate 1G/2.5G/5G/10G SFP+ to RJ-45 Module
$71.99