-
Problem when configuring network on Knoppix 5.1.0 !
Hello. I have a problem installing my network/internet connection on Knoppix 5.1.0. I use the GUI interface found under Knoppix/Net/ Network Card Configuration. With same properties the inetrenet connection works fine with Knoppix 3.9 and Knoppix-STD ( i don't remember the version ). I think that there's a problem with resolving the names.
How can i configure manually the network ?
> eth0 x.x.x.x netmask x.x.x.x broadcast x.x.x.x up
> route add default gw x.x.x.x
And then what ?
Thank you in advance !
Mitko Kostov, Bulgaria.
-
Senior Member
registered user
Try this : if you can boot-up another system that works with your netcard, use it to obtain your router or modem address as applicable, and (optionally, to avoid unnecessary proliferation of addresses), the address that it allocates to your network card under DHCP.
They are likely to be of the forms (substitute your own figures):
192.168.A.B for the modem/router
192.168.A.C for the netcard
Then in Knoppix netcardconfig answer NO to DHCP,
enter 192.168.A.C for the netcard address
enter 255.255.255.0 Subnet Mask
enter 192.168.A.255 Broadcast
enter 192.168.A.B for Nameserver and Gateway
(Reference: http://www.knoppix.net/forum/viewtop...287&highlight= )
Also you might have to command: ifconfig eth0 mtu 1500
(Reference: http://www.knoppix.net/forum/viewtopic.php?t=26867 )
Good luck
-
The thing is that my net provider doesn't use DHCP and i have configured proparly and worked with the addresses for eth0, netmask, gateway and broadcast on Knoppix 3.9 and STD, but on 5.1.0 there's a problem.
-
Administrator
Site Admin-
---
Verifying of md5 checksum and burning a CD at slow speed are important.
-
This post cannnot help me, beacause there is nothing helpful for me. I want to know how to start the nameserver, after editing /etc/resolv.conf.
-
Senior Member
registered user
Originally Posted by
Fly
The thing is that my net provider doesn't use DHCP and i have configured proparly and worked with the addresses for eth0, netmask, gateway and broadcast on Knoppix 3.9 and STD, but on 5.1.0 there's a problem.
[1] OK then from this you know your "nameserver/gateway" address (and the other network addresses !!! ) to enter into netcardconfig when you answer "NO" to "Obtain address automaticaly (DHCP)?"
!!! But DO NOT use Broadcast 255.255.255.255 with Knoppix 5.1 (please see earlier posting Friday Mar 16, 2007 5;17pm)
Originally Posted by
Fly
This post cannnot help me, beacause there is nothing helpful for me. I want to know how to start the nameserver, after editing /etc/resolv.conf.
[2] Have you confirmed that /etc/resolv.conf was correctly edited by netcardconfig as used in [1] above ?
[3] What is the value of MTU shown by the command: iconfig eth0 ?
(if you still have a problem it would help to post the full output of iconfig eth0 )
-
Hello again. The problem was very simple : i configured eth0 and my LAN card was identifyied as eth1.
I'm really sorry.
Similar Threads
-
By kckirk3 in forum Networking
Replies: 0
Last Post: 06-16-2009, 06:41 PM
-
By uncleelvis in forum Networking
Replies: 10
Last Post: 09-21-2008, 06:53 AM
-
By pboodi in forum Networking
Replies: 0
Last Post: 07-22-2006, 11:32 PM
-
By berto in forum Networking
Replies: 1
Last Post: 03-01-2004, 02:03 AM
-
By johnsandidge in forum Networking
Replies: 2
Last Post: 01-06-2004, 04:02 PM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Samsung Galaxy Tab A8 10.5" SM-X200 128GB Wifi Only Tablet Open Box
$149.99
Genuine Samsung Book Cover Keyboard for 14.6" Galaxy Tab S8 Ultra | S8 Ultra 5G
$89.99
Samsung - S Pen Creator Edition - White
$40.00
Samsung Galaxy Tab A9 (X110) 64GB 4GB RAM International Version (New)
$129.99
Samsung Galaxy 12.4 Inch Slim Keyboard For S7+ | S7 FE | S8+ | S8+ 5G EF-DT730
$49.99
Samsung Galaxy Tab E 8" 16GB Black SM-T377V (Verizon) Android Tablet IG1000
$30.35
Samsung Galaxy Chromebook Go, 14-inch, 32GB, Unlocked All Carriers - Silver
$109.99
Samsung USB 3.1 Flash Drive Bar Plus 256gb TITAN Gray
$24.10
SAMSUNG 24" Monitor Full HD LED/LCD - GRADE A CONDITION - S24E650PL
$69.95
Samsung 22 In LED-backlit LCD monitor, S22E450D
$45.00