Dear experts,
I'm an utter newbie to Linux and am just fiddling aboot a bit, but when trying out the Knoppix CD on my new Medion 8818, I get an error message (most probably screen-related) after having seen the Knoppix CD actually start up
It says:
Mode not supported
H : 15.0KHz V : 18.8Hz
After which the screen actually just completely fails to do anything but stare at me with all its blackness plus this one message.
Can anyone tell me what I could possibly do? Any piece of advice would be most awfully welcome...
CK
Cisco Catalyst C9300-24UX-A 24 Port 10G/mGig UPOE Network Switch, no module
$299.97
Cisco Catalyst C9300-24UX-A 24 Port 10G/mGig UPOE Network Switch + NM-8X Module
$599.97
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W+ C3850-NM-4-1G Mod
$89.00
Cisco WS-C3850 48 Port Gigabit PoE+ Switch C3850-NM-2-10G 1100W
$89.99
Cisco WIC-1AM-V2 1-Port Analog V.92 Modem WAN Interface Card - 1 Year Warranty
$5.95
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Cisco C3850-NM-4-10G 4 Port Network Exp.Module for 3850
$124.99
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$32.90
Cisco WS-C4500X-16SFP+ 16 Port SFP Switch Dual AC. #4
$90.00
Cisco STACK-T4-3M Stacking Cable New Sealed
$149.00