I figured this one out by myself:
The command is umount, not uNmount.
Hello,
I was following the remastering steps from
http://www.knoppix.net/wiki/Knoppix_Remastering_Howto
and I can't do the "unmount /proc" from the "Leaving Chroot" section. I get an error from bash:
bash: unmount: command not found.
Any kind advice on what do to?
Thanks,
Frank
I figured this one out by myself:
The command is umount, not uNmount.
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$37.21
JUNIPER ELECTRONICS NFX250-ATT-LS1
$250.00
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$59.95
Juniper EX2300-48P 48-Port Gigabit Ethernet Switch PoE+ 4x SFP+ Power Cable
$104.40
Juniper EX3300-48P 48-Port 10/100/1000BASE-T (48 PoE+ ports) with 4 SFP+
$74.00
$2100.00
Juniper 48-Port PoE GbE Network Switch w/ 4-Port 10GB SFP+ Module EX4300-48P
$179.99
Juniper EX3300-48P, 48 Port PoE+ Gigabit Network Switch with RACK EARS, RESET
$46.99
Juniper Networks EX2300-C-12T Compact 12-Port EX2300-C Series Ethernet Switch
$300.00
JUNIPER SRX340 SERVICE GATEWAY APPLIANCE Tested/Working #73
$111.99