I figured this one out by myself:
The command is umount, not uNmount.
Hello,
I was following the remastering steps from
http://www.knoppix.net/wiki/Knoppix_Remastering_Howto
and I can't do the "unmount /proc" from the "Leaving Chroot" section. I get an error from bash:
bash: unmount: command not found.
Any kind advice on what do to?
Thanks,
Frank
I figured this one out by myself:
The command is umount, not uNmount.
Cisco UCS LSI MegaRAID 9271CV-8I SAS2308 PCIe SAS Internal RAID Controller
$28.00
ACASIS 2.5/3.5 inch 2 Bay SATA USB 3.0 Hard Drive Disk HDD SSD Enclosure 4 RAID
$58.99
Intel PCIe SSD AIC RAID Controller Card G97168-252
$44.55
LSI 9305-16i SATA SAS 12Gbs RAID Controller PCIe 3.0 x8 IT-Mode 4* 8643 SATA
$229.99
Inspur LSI 9300-8i Raid Card 12Gbps HBA HDD Controller High Profile IT MODE
$15.98
LSI MegaRAID 9361-8i 12Gb PCIe 8-Port SAS/SATA RAID 1Gb w/BBU/CacheVault/License
$39.95
LSI MegaRaid 9361-8i 12Gbps SAS / SATA Raid Controller PCIe x8 3.0 Tested
$29.00
ORICO Multi Bay RAID Hard Drive Enclosure USB 3.0/ Type-C For 2.5/3.5'' HDD SSDs
$87.99
4 Bay RAID External Hard Drive Enclosure for 2.5/3.5" SATA HDD/SSD
$79.99
G TECHNOLOGY G RAID 0G04228 2-Bay Thunderbolt 2 RAID Array W/Power Supply
$99.99