-
have to run pppoeconf every time
Hello, my PC is a common one, with 8139 netcard, and without any special hardware.
I have only one PC, and connect with internet through adsl. directly, without router or hub.
I installed Knoppix5.1.1 as Debian in my hardware, and I found this is a good distro except one bore.
I have to configure my pppoe by typing "pppoeconf" in konsole every time after booting my knoppix, or internet cannot be connected. I noticed that one line of boot scrolling is "Failed to bring up eth0"
On my other partitions, I installed Simplymepis and Dreamlinux. With this systems, I needn't configure pppoe every time. Internet conncetion is always ready after booting.
what is the matter? What can i do with it?
-
Administrator
Site Admin-
Knoppix is well known to break after a hard disk install, and problems with networking may be the most common symptom. I have been seeing this for over for years now. You didn't say, but if it worked fine from CD then you have already demonstrated this. I urge you to try a distro like Debian that does not have this and other problems, but offers all of the software and features that Knoppix does.
While Knoppix has pppoe software to run your dsl connection without a router, I urge you to get one and operate safely (I'm assuming your dsl modem does not have one built in, you imply it does not). Even with only one computer you are much better off behind a NAT router, particularly if you ever run Windows.
---
Verifying of md5 checksum and burning a CD at slow speed are important.
Similar Threads
-
By plener in forum Networking
Replies: 0
Last Post: 02-22-2006, 01:43 PM
-
By jacksonon in forum Networking
Replies: 5
Last Post: 09-01-2005, 07:41 AM
-
Replies: 4
Last Post: 11-25-2003, 04:28 PM
-
By oscar in forum Customising & Remastering
Replies: 0
Last Post: 05-23-2003, 12:55 AM
-
By guest in forum Hdd Install / Debian / Apt
Replies: 6
Last Post: 12-30-2002, 06:52 AM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Cisco Nexus (N2K-C2232PP) 32-Ports Rack-Mountable Expansion module -
$62.99
Cisco SG95-16 16-Port Gigabit Switch SG95-16-KR
$47.00
Cisco Meraki MS120-48LP 48 Port Blade Ethernet Switch UNCLAIMED
$799.00
Cisco C3900-SPE200/K9 Cisco Services Performance Engine 200
$109.95
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W+ C3850-NM-4-1G Mod
$83.00
Cisco QSFP-40G-SR-BD BiDi Short-reach Transceiver, 1 Year Warranty
$17.25
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$38.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Cisco WS-C3850-48F-S Catalyst 3850 48x 1GB PoE+ RJ-45 1x Module Switch
$185.00
Cisco C9300-48 48 Port Switch Dual PSU W/C9300-NM-8X P/N: C9300-48U-A Tested
$799.99