"swapon -s" will list the status of your swap partition(s)
"vmstat" or even "top" will mention swap usage (but probably not the details if you've got several partitions)
There are probably GUI equivalent but this should get you going![]()
HI!
Whenever I knoppix-installer a new PC, I always run qtparted first to set up dual partitions (hda1=wimpdoze, hda2=knoppix) and a swap partition.
My question is, how do I know that I set up the swap properly? Is there someway to see if its being used and what percentage of it is loaded at any given time?
TIA,
AJG
"swapon -s" will list the status of your swap partition(s)
"vmstat" or even "top" will mention swap usage (but probably not the details if you've got several partitions)
There are probably GUI equivalent but this should get you going![]()
OK, thanx a lot! I give that a try.
Regards,
AJG
DOH! Why didn't I think of top???
Thanx,
AJG
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$95.00
New Precision DWDM SFP+ 10G 80km Tunable Transceiver 50GHz C-Temp DWDM-SFP10G-C
$90.00
New Cisco SFP-10G-LRM 10G SFP+ LRM 1310nm 220m SMF/MMF LC Module
$34.99
For Cisco SFP-10G-T, Ubiquiti UF-RJ45-10G Transceiver, SFP+ to RJ45 10GBase-T
$49.99
🔥🔥🔥 CISCO SFP-10G-SR V03 10-2415-03 850nm 10GBASE-SR SFP+ Multi Module 🔥🔥🔥
$6.80
GENUINE Cisco SFP-10G-SR V03 SFP+ GBIC Transceiver Module 10-2415-03
$6.80
SFP-H10GB-CU3M Cisco 10GB SFP+ Twinax Copper 3M Passive Cable
$7.99
Genuine Cisco ‎SFP-10G-SR Transceiver Module (10-2415-03)
$5.85
New Cisco GLC-TE 1G SFP Copper RJ45 100m 1000BASE-T Transceiver Module
$23.50
New HP HPE Aruba J4858D 1G SFP LC SX 850nm 500m MMF XCVR Transceiver Module
$29.99