"swapon -s" will list the status of your swap partition(s)
"vmstat" or even "top" will mention swap usage (but probably not the details if you've got several partitions)
There are probably GUI equivalent but this should get you going
HI!
Whenever I knoppix-installer a new PC, I always run qtparted first to set up dual partitions (hda1=wimpdoze, hda2=knoppix) and a swap partition.
My question is, how do I know that I set up the swap properly? Is there someway to see if its being used and what percentage of it is loaded at any given time?
TIA,
AJG
"swapon -s" will list the status of your swap partition(s)
"vmstat" or even "top" will mention swap usage (but probably not the details if you've got several partitions)
There are probably GUI equivalent but this should get you going
OK, thanx a lot! I give that a try.
Regards,
AJG
DOH! Why didn't I think of top???
Thanx,
AJG
Cisco SG110 24 Port Gigabit Ethernet Switch w/ 2 x SFP SG110-24
$117.00
Mellanox 10/25GbE SFP28 Network Card MCX512A-ACAT ConnectX-5 EN Ethernet Adapter
$284.00
1783-SFP1GTE Allen Bradley 1G copper SFP #ZYPL
$879.87
Cisco 110 24 Port 10/100 Ethernet Switch with 2 x SFP SF112-24-NA
$90.00
NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*
$18.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
F5 Networks 10GB OPT-0016-00 F5-UPG-SFP+-R 10GBASE/SR SFP Transceiver
$4.00
Mellanox Original MFM1T02A-SR 10GbE 10GBASE-SR SFP+ Transceiver
$9.00
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00