"swapon -s" will list the status of your swap partition(s)
"vmstat" or even "top" will mention swap usage (but probably not the details if you've got several partitions)
There are probably GUI equivalent but this should get you going
HI!
Whenever I knoppix-installer a new PC, I always run qtparted first to set up dual partitions (hda1=wimpdoze, hda2=knoppix) and a swap partition.
My question is, how do I know that I set up the swap properly? Is there someway to see if its being used and what percentage of it is loaded at any given time?
TIA,
AJG
"swapon -s" will list the status of your swap partition(s)
"vmstat" or even "top" will mention swap usage (but probably not the details if you've got several partitions)
There are probably GUI equivalent but this should get you going
OK, thanx a lot! I give that a try.
Regards,
AJG
DOH! Why didn't I think of top???
Thanx,
AJG
HP ProLiant MicroServer Gen8 Server Xeon E3-1220L 16GB RAM No HDD's
$299.00
HP Proliant MicroServer Gen 8 2.3GHz CPU 16GB RAM NO DRIVES/CADDIES INCLUDED
$179.99
HP ProLiant HSTNS-5151 Micro Server 8GB RAM No Drives/Key/Caddies *READ*
$94.99
HP ProLiant MicroServer Gen8 Server Xeon E3-1220L 8GB RAM No HDD's
$229.99
HPE ProLiant MicroServer Gen 10 Plus, Xeon E-2224, 16GB DDR4, 1TB M.2 NVMe SSD
$750.00
ProLiant MicroServer Gen8 Intel Xeon E3-1220L V2 2.3GHz CPU 8GB RAM
$170.00
HP ProLiant MicroServer Gen8 Server Intel Xeon E3-1220L v2 16GB DDR3 (4) 4TB HDs
$399.00
HP ProLiant N36L Micro Server 633724-001 AMD Athlon II Neo N36L - No HDDs
$82.07
HP ProLiant Microserver Micro Server HSTNS-5151 untested
$75.00
HPE ProLiant MicroServer Gen10 Plus v2 Ultra Micro Tower Server P54644001
$849.99