"swapon -s" will list the status of your swap partition(s)
"vmstat" or even "top" will mention swap usage (but probably not the details if you've got several partitions)
There are probably GUI equivalent but this should get you going
HI!
Whenever I knoppix-installer a new PC, I always run qtparted first to set up dual partitions (hda1=wimpdoze, hda2=knoppix) and a swap partition.
My question is, how do I know that I set up the swap properly? Is there someway to see if its being used and what percentage of it is loaded at any given time?
TIA,
AJG
"swapon -s" will list the status of your swap partition(s)
"vmstat" or even "top" will mention swap usage (but probably not the details if you've got several partitions)
There are probably GUI equivalent but this should get you going
OK, thanx a lot! I give that a try.
Regards,
AJG
DOH! Why didn't I think of top???
Thanx,
AJG
Cisco Systems NCS2K-20-SMRFS-L optical multiplexor CISCO EXCESS
$3599.00
Cisco SG110 24 Port Gigabit Ethernet Switch w/ 2 x SFP SG110-24
$117.00
Cisco RV160 VPN Router 4 Gigabit Ethernet Ports RV160-K9-AR
$80.00
Cisco AironetAIR-AP2802I-Q-K9 IEEE 802.11ac 5.20 Gbit/s Wireless Access Point
$130.00
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W+ C3850-NM-4-1G Mod
$83.00
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$38.99
Cisco Catalyst WS-C2960-48TT-L V02 48 Port Fast Ethernet Switch
$34.00
Cisco WS-C4948-10GE-S 4948-10GE 48 Port Gigabit +10GB Switch w single AC 15.0 OS
$99.99
NEW SEALED Cisco C9300L-STACK-KIT
$479.99
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W Network Switch
$41.58