"swapon -s" will list the status of your swap partition(s)
"vmstat" or even "top" will mention swap usage (but probably not the details if you've got several partitions)
There are probably GUI equivalent but this should get you going
HI!
Whenever I knoppix-installer a new PC, I always run qtparted first to set up dual partitions (hda1=wimpdoze, hda2=knoppix) and a swap partition.
My question is, how do I know that I set up the swap properly? Is there someway to see if its being used and what percentage of it is loaded at any given time?
TIA,
AJG
"swapon -s" will list the status of your swap partition(s)
"vmstat" or even "top" will mention swap usage (but probably not the details if you've got several partitions)
There are probably GUI equivalent but this should get you going
OK, thanx a lot! I give that a try.
Regards,
AJG
DOH! Why didn't I think of top???
Thanx,
AJG
Cisco SG95-16 16-Port Gigabit Switch SG95-16-KR
$47.00
Cisco (SG100D-05-UK) 5-Ports External Ethernet Switch
$40.00
Cisco SG110 24 Port Gigabit Ethernet Switch w/ 2 x SFP SG110-24
$117.00
Cisco SG110D-08HP 8-Port Gigabit PoE Unmanaged Switch SG110D-08HP-JP
$87.00
HP 2530-48G 48 Port Gigabit Ethernet Network Switch J9775A
$30.95
New Linksys SE3005 5-port Gigabit Ethernet Switch
$18.99
Linksys SE3008 8 Ports Rack Mountable Gigabit Ethernet Switch
$21.99
HP ProCurve 2530-24G J9776A 24 Port Gigabit Ethernet Managed Network Switch
$34.99
Netgear Prosafe Plus JGS524PE 24 Port Gigabit Switch 12 Port PoE JGS524PE-100NAS
$129.98
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95