Hi there --
I completed an installation of Knoppix 5.1.1 onto a Dell PowerEdge 1850 system. The configuration that I used was beginner to allow a Debian-like setup with the hardware detection scripts made available.
The problem that I am having is the following: Whenever I insert my Lexar USB 1.0 GB Jumpdrive, the system detects it, but it cannot see anything on it. When I try to open the drive, the following error message appears onscreen:
Could not mount device
mount wrong fs type, bad option, bad superblock on /dev/sdb1 missing codepage or some other error
I ran dmesg, and the following output appeared:
usb-storage: device scan complete
FAT: Unrecognized mount option "uid-knoppix" or missing value
FAT: Unrecognized mount option "uid-knoppix" or missing value
Has anyone seen this, and know what I can do to correct it? Thanks.
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
Pair Micron 16GB (2x8GB) PC4-21300 DDR4-2666VMHz Non-ECC Desktop Memory Ram
$19.95
HyperX FURY DDR3 8GB 16GB 32GB 1600 MHz PC3-12800 Desktop RAM Memory DIMM 240pin
$12.90
A-Tech 8GB PC3-12800 Desktop DDR3 1600 MHz Non ECC 240-Pin DIMM Memory RAM 1x 8G
$13.99
A-Tech 16GB 2 x 8GB PC3-12800 Laptop SODIMM DDR3 1600 Memory RAM PC3L 16G DDR3L
$27.98
8GB PC3L-12800S 1600MHz SODIMM DDR3 RAM | Grade A
$12.00
Kingston HyperX FURY DDR3 8GB 16GB 32G 1600 1866 1333 Desktop Memory RAM DIMM
$13.25
Samsung 16GB (2x8GB) PC3L-12800S Lap Top Memory RAM
$20.00
A-Tech 256GB 4x 64GB 4Rx4 PC4-19200 ECC Load Reduced LRDIMM Server Memory RAM
$287.96
A-Tech 256GB 8x 32GB 4Rx4 PC4-17000L DDR4 2133 MHz ECC LRDIMM Server Memory RAM
$319.92