Hi there --
I completed an installation of Knoppix 5.1.1 onto a Dell PowerEdge 1850 system. The configuration that I used was beginner to allow a Debian-like setup with the hardware detection scripts made available.
The problem that I am having is the following: Whenever I insert my Lexar USB 1.0 GB Jumpdrive, the system detects it, but it cannot see anything on it. When I try to open the drive, the following error message appears onscreen:
Could not mount device
mount wrong fs type, bad option, bad superblock on /dev/sdb1 missing codepage or some other error
I ran dmesg, and the following output appeared:
usb-storage: device scan complete
FAT: Unrecognized mount option "uid-knoppix" or missing value
FAT: Unrecognized mount option "uid-knoppix" or missing value
Has anyone seen this, and know what I can do to correct it? Thanks.
$500.00
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$359.99