Hi there --
I completed an installation of Knoppix 5.1.1 onto a Dell PowerEdge 1850 system. The configuration that I used was beginner to allow a Debian-like setup with the hardware detection scripts made available.
The problem that I am having is the following: Whenever I insert my Lexar USB 1.0 GB Jumpdrive, the system detects it, but it cannot see anything on it. When I try to open the drive, the following error message appears onscreen:
Could not mount device
mount wrong fs type, bad option, bad superblock on /dev/sdb1 missing codepage or some other error
I ran dmesg, and the following output appeared:
usb-storage: device scan complete
FAT: Unrecognized mount option "uid-knoppix" or missing value
FAT: Unrecognized mount option "uid-knoppix" or missing value
Has anyone seen this, and know what I can do to correct it? Thanks.
Cisco WS-C3560-48PS-S 48-Port Managed Gigabit PoE Switch
$56.00
Cisco WS-C3650-48FD-S 48-Port Gigabit Managed Switch
$49.99
Cisco SG95-16 16-Port Gigabit Switch SG95-16-KR
$47.00
Cisco 24-Port Managed Gigabit Switch WS-C3750G-24TS-S
$49.99
HP 2530-48G 48 Port Gigabit Ethernet Network Switch J9775A
$30.95
Linksys SE3008 8 Ports Rack Mountable Gigabit Ethernet Switch
$21.99
New Linksys SE3005 5-port Gigabit Ethernet Switch
$18.99
HP ProCurve 2530-24G J9776A 24 Port Gigabit Ethernet Managed Network Switch
$34.99
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95
Netgear Prosafe Plus JGS524PE 24 Port Gigabit Switch 12 Port PoE JGS524PE-100NAS
$129.98