Hi there --
I completed an installation of Knoppix 5.1.1 onto a Dell PowerEdge 1850 system. The configuration that I used was beginner to allow a Debian-like setup with the hardware detection scripts made available.
The problem that I am having is the following: Whenever I insert my Lexar USB 1.0 GB Jumpdrive, the system detects it, but it cannot see anything on it. When I try to open the drive, the following error message appears onscreen:
Could not mount device
mount wrong fs type, bad option, bad superblock on /dev/sdb1 missing codepage or some other error
I ran dmesg, and the following output appeared:
usb-storage: device scan complete
FAT: Unrecognized mount option "uid-knoppix" or missing value
FAT: Unrecognized mount option "uid-knoppix" or missing value
Has anyone seen this, and know what I can do to correct it? Thanks.
128GB Kit 4x 32GB PC4-17000 LRDIMM DELL POWEREDGE R730xd R730 R630 Memory RAM
$127.96
CORSAIR Vengeance RGB 32GB (2 x 16GB) PC RAM DDR5 6000mhz CL30 AMD Expo
$75.00
Crucial 8GB 1x8GB PC RAM PC3L 12800U DDR3 1600MHz Desktop Memory DIMM
$8.99
Team T-FORCE VULCAN Z 16GB (2 x 8GB) 288-Pin PC RAM DDR4 3200 (PC4 25600) Memory
$24.99
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
Micron 16GB DDR4-2400 SODIMM MTA16ATF2G64HZ-2G3E1 Laptop Memory RAM
$21.99
Crucial DDR3L 16GB 1600 2x 8GB PC3-12800 Laptop SODIMM Memory RAM PC3 16G DDR3
$22.45
SK Hynix 8GB DDR4 1Rx16 -PC4-3200AA/ HMAA1GS6CJR6N-XN SODIMM
$10.00
Lot of 50 DDR4 8GB PC4-2666V Laptop Memory RAM Mixed Major Brands
$474.99
APPLE MACBOOK AIR 13 INCH LAPTOP | 8GB RAM | 256GB SSD | WARRANTY | 2017-2020
$349.00