Hi there --
I completed an installation of Knoppix 5.1.1 onto a Dell PowerEdge 1850 system. The configuration that I used was beginner to allow a Debian-like setup with the hardware detection scripts made available.
The problem that I am having is the following: Whenever I insert my Lexar USB 1.0 GB Jumpdrive, the system detects it, but it cannot see anything on it. When I try to open the drive, the following error message appears onscreen:
Could not mount device
mount wrong fs type, bad option, bad superblock on /dev/sdb1 missing codepage or some other error
I ran dmesg, and the following output appeared:
usb-storage: device scan complete
FAT: Unrecognized mount option "uid-knoppix" or missing value
FAT: Unrecognized mount option "uid-knoppix" or missing value
Has anyone seen this, and know what I can do to correct it? Thanks.
Juniper Networks EX2300-C-12T Compact 12-Port EX2300-C Series Ethernet Switch
$300.00
Juniper Networks EX2300-48P 48 Port Gigabit PoE 4 SFP 1/10G Network Switch
$185.00
Juniper Networks EX2200-C-12P-2G Gigabit Ethernet Managed Switch
$79.99
Juniper EX3400-48P 48-Ports PoE+ 4x SFP+ and 2x QSFP+ Managed Switch Tested
$135.00
Juniper Networks EX3300-24P | 24 Port Gigabit Network Switch w/ Power cord
$53.99
Juniper EX4200-48PX 48-PORT 10/100/1000BASET PoE Ethernet Switch
$50.00
Juniper Networks EX2200-C Ethernet Managed Switch w/ Rack Mounts
$74.99
Juniper EX3400-48P 48 Port Switch PoE+ 4x SFP+ 2x QSFP 1xAC *Tested/Warranty*
$139.95
Juniper Networks SRX220 8-Port Gigabit Services Gateway Security Appliance
$45.00
Juniper Networks EX4400-48MP 48 port 5GbE + 12 port 10 Gigabit PoE++ Switch -NEW
$1400.00