I have installed Knoppix on a single partition and Swap is a different partition. When ther is power outage, sometimes the system will not come up giveing error. Later I have to boot from the cd and run fsck on this partition which solves the problem and I can boot from the HDD. On solaris when I enabled journalling in fstab this problem did not occur. Since reisfs is a journaliing file system, the FS should never be inconsistent. Do I have to change entries in fstab for this partition? If so wha should be the entry?
I installed Knoppix version 5.0 on HDD. Sometimes when there is a power flutuation, the Graphics will not come up during the next boot. Everything will work in character mode. Running fsck will not work How to tackle this? Or do I have to re-install the full system again from scratch?
I have broadband internet connection and when I boot Knoppix 5.0 from HDD I use PPPOE configuration tool to use the internet. The problem is that after every reboot again I have to do this procedure. How to preserve this across multiple boots from the HDD?
New Precision DWDM SFP+ 10G 80km Tunable Transceiver 50GHz C-Temp DWDM-SFP10G-C
$90.00
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$95.00
LOT OF 10 HPE JD092B X130 10G SFP+ LC SR Transceiver
$40.00
New Cisco SFP-10G-LRM 10G SFP+ LRM 1310nm 220m SMF/MMF LC Module
$32.19
🔥🔥🔥 CISCO SFP-10G-SR V03 10-2415-03 850nm 10GBASE-SR SFP+ Multi Module 🔥🔥🔥
$6.80
GENUINE Cisco SFP-10G-SR V03 SFP+ GBIC Transceiver Module 10-2415-03
$6.80
Genuine Cisco ‎SFP-10G-SR Transceiver Module (10-2415-03)
$5.85
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$12.99
For Cisco SFP-10G-T, Ubiquiti UF-RJ45-10G Transceiver, SFP+ to RJ45 10GBase-T
$44.09
Fully Compatibility 10GBase-T Transceiver SFP-10G-T SFP+ to RJ45 Copper 30M 80M
$45.00