Yes. Can't do any harm, anyway!
Hi, Just ran knx-install.
When in the partitioning section, I create a new primary partition, hda2 (windows is hda1), and a logical hda5, set hda5 to swap. this all goes well. Later I choose to install lilo to mbr. When the install is finished I reboot, but no lilo menu, windowz just bootes up. What am I doing wrong? Should I set hda2 to bootable? (hda1 is marked bootable in cfdisk)
btw it's knoppix 3.2 may 20
Yes. Can't do any harm, anyway!
I was sort of hoping for a yes/no answer
you get aboutOriginally Posted by fingers99
hmm... I created a boot disk during the last install, forgot it was in the drive. So I'm in knoppix at the moment. Is there a tool or script or something to re-install lilo?
Alrighy then! Knoppix is officially up and running here. nice. about bloody time
Seems lilo got a bit weird about my promise controller(not raid) and the 2 hddsks attached to it. I removed the entries from lilo.conf and ran lilo config and presto, lilo installed fine.
Thanks for the quick replies though
/Orv
1U Supermicro Server 10 Bay 2x Intel Xeon 3.3Ghz 8C 128GB RAM 480GB SSD 2x 10GBE
$297.00
HPE ProLiant MicroServer Gen8 Intel Xeon E3-1265L 16GB ECC PCIe x16 4x1TB HDD
$249.99
HP ProLiant Xeon E3-1220L V2 MicroServer Gen8 2.30 GHz 16 GB RAM NO DRIVES
$199.99
HPE ProLiant MicroServer Gen10 Plus v2 Ultra Micro Tower Server - 1 x Intel Xeon
$846.19
SuperMicro Server 505-2 Intel Atom 2.4GHz 8GB RAM SYS-5018A-FTN4 1U Rackmount
$202.49
HP ProLiant HSTNS-5151 Micro Server 8GB RAM No Drives/Key/Caddies *READ*
$94.99
Supermicro 5018A-FTN4 Rack Server - Black
$125.00
Microsel Server Tower Supermicro X10SAE E3-1275 V3 @3.5GHz 16GB 509849-001
$149.99
SUPERMICRO CSE-512 AMD Opteron Processor 6128, 32GB DDR3 RAM NO HDD
$90.00
1U 20" Short Depth Server Firewall PFSense X11SSH-F Xeon 3.5Ghz 32GB RAM NVME
$247.00