Yes. Can't do any harm, anyway!
Hi, Just ran knx-install.
When in the partitioning section, I create a new primary partition, hda2 (windows is hda1), and a logical hda5, set hda5 to swap. this all goes well. Later I choose to install lilo to mbr. When the install is finished I reboot, but no lilo menu, windowz just bootes up. What am I doing wrong? Should I set hda2 to bootable? (hda1 is marked bootable in cfdisk)
btw it's knoppix 3.2 may 20
Yes. Can't do any harm, anyway!
I was sort of hoping for a yes/no answer
you get aboutOriginally Posted by fingers99
hmm... I created a boot disk during the last install, forgot it was in the drive. So I'm in knoppix at the moment. Is there a tool or script or something to re-install lilo?
Alrighy then! Knoppix is officially up and running here. nice. about bloody time
Seems lilo got a bit weird about my promise controller(not raid) and the 2 hddsks attached to it. I removed the entries from lilo.conf and ran lilo config and presto, lilo installed fine.
Thanks for the quick replies though
/Orv
Silicom (PE210G2SPI9A-XR) 10Gb Dual Port SFP+ PCIe Ethernet Adapter Low Profile
$19.99
Cisco Nexus 48-Port 10G SFP+ Switch N9K-9396PX w/ 9K-M12PQ 12-Port 40G QSFP
$249.99
Lot of 2 - Dell Intel X520-DA2 2x 10GB SFP+ PCIe Ethernet Network Adapter 942V6
$53.99
SFP-10G-LR Compatible 10GBase-LR SFP+ LR Transceiver 10G 1310nm SMF up ot 10km
$45.00
NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*
$18.00
F5 Networks 10GB OPT-0016-00 F5-UPG-SFP+-R 10GBASE/SR SFP Transceiver
$4.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Mellanox Original MFM1T02A-SR 10GbE 10GBASE-SR SFP+ Transceiver
$9.00
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00
Cisco 10G SFP+ Module SFP-10G-SR 10-2415-03 (Lot of 5)
$24.99