You don't want to use the install script. That's ok, but then what you need to do is essentially do every step in the install script by hand.
If you want to change paths, then you must be very careful to change them in all locations (files).
Hi there.
I've build a LiveCD called Lunix Live which is based on Gentoo Linux i686 using XFCE 4.4.1.
Now i want to install Klik onto it. So i have a few questions.
Is it possible to install Klik on this Gentoo-based LiveCD using XFCE4?
I tried not to execute the install script, instead i wanted to copy the files 'by hand'.
I had a look at the install file to figure out what files are needed. Also i looked at
this page: http://www.pro-linux.de/berichte/klik.html#ToC9. There's a german howto about
what files are copied/removed to un/install Klik.
There are only descriptions about how to install klik using KDE, but none using XFCE4.
I thing Klik is the right solution for my LiveCD (Lunix Live), cause its possible to install programs
temporary, which are not installed on my small (398M) Live distribution.
I don't want to execute the install script, i want to copy each file needed by Klik to
its destination. Can someone tell my how to do this using the XCFE4 directory structure
not the KDE one.
I hope someone can explain me how to install Klik on the Live system described above.
Thanks for your help...
_morpheus_
You don't want to use the install script. That's ok, but then what you need to do is essentially do every step in the install script by hand.
If you want to change paths, then you must be very careful to change them in all locations (files).
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 88-2SIO Reproduction Board
$35.00
1974 Early Microcomputers by MITS Altair 8800's Ed Roberts HP-9810 Mark-8 Scelbi
$55.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
$85.95
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
Altair SD PROM 100 2708 2716 2732 EPROM Programmer board Card S100 PCB #AX49
$249.00