# xedit /etc/aumixrc
You can adjust these values- be careful. I run mine at 99. Don't know what maximum is.Code:vol:79:79:P synth:79:79:R pcm:79:79:P speaker:0:0:R line:79:79:R mic:0:0:R cd:79:79:R
I have an IBM A30 Laptop with Knoppix 3.2 installed. When I installed it, it did not detect my soundcard correctly. I ran sndconfig, and it worked.
Now, when I start up, there is no sound. I open mixer, change the levels slightly (they are about 75%, any other level, even lower works) and then sound works for that session, but not on reboot, I have to do the same again.
Any thoughts?
Thanks
# xedit /etc/aumixrc
You can adjust these values- be careful. I run mine at 99. Don't know what maximum is.Code:vol:79:79:P synth:79:79:R pcm:79:79:P speaker:0:0:R line:79:79:R mic:0:0:R cd:79:79:R
I'll try this, but it isn't that the level is too, low, but that I have to change it when the system starts up. Even reducing the volume works. Why should that be?
OIC- perhaps you are not saving your sessions on logout?
How would I know whether I am?
I don't think this is the problem however, since the levels are set at about 75% on startup, there is just no sound, I only need to change them to get sound. Even if I put them back at 75%, it is the act of changing the levels that seems to switch the sound on.
hmmmmmmmm- Are you aware that there are two mixers? kimix & aumix.
To save your sessions on log out:
Control Center>KDE Components>SessionManager
If that doesn't get it working perhaps you should look at your soundcard drivers.
Ah ha, no, I'll check that...
Thanks!
New Precision DWDM SFP+ 10G 80km Tunable Transceiver 50GHz C-Temp DWDM-SFP10G-C
$90.00
LOT OF 10 HPE JD092B X130 10G SFP+ LC SR Transceiver
$40.00
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$95.00
LOT OF 10 455883-B21 HP 10Gb SR SFP Transceiver 455885-001 456096-001
$59.99
🔥🔥🔥 CISCO SFP-10G-SR V03 10-2415-03 850nm 10GBASE-SR SFP+ Multi Module 🔥🔥🔥
$6.80
GENUINE Cisco SFP-10G-SR V03 SFP+ GBIC Transceiver Module 10-2415-03
$6.80
Genuine Cisco ‎SFP-10G-SR Transceiver Module (10-2415-03)
$5.85
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$12.99
Fully Compatibility 10GBase-T Transceiver SFP-10G-T SFP+ to RJ45 Copper 30M 80M
$58.50
New Cisco SFP-10G-LRM 10G SFP+ LRM 1310nm 220m SMF/MMF LC Module
$32.19